American access system ADV-1000 Manuale delle Istruzioni Scaricare il pdf (Pagina 9)

SUB-MODE DESCRIPTION

1 Program Access Codes (Relay A)

2 Delete Codes

3 Change Master Code

4 Set Sleep Code

5 Set Latch Code

6 Set Relay Output Times

7 Program Access Codes (Relay B)

8 Enable / Disable "3 Strikes-You’re Out"

9 Program Event Input

0 Erase Memory

♦

♦♦

♦

Sub-Mode 1 (Program Relay A Access Codes)

To program new Relay A access codes enter the following;

(MASTER CODE) + 1 + (NEW CODE) + (NEXT NEW CODE) etc......... ( # to exit)

Should you make a code entry error, simply press the * key and enter the correct code. You may select any 4 digit code

you wish. If you receive an ERROR after entry, you must select another code as it is already in use. The unit will

respond with a GOOD BEEP with the acceptance of each new Relay A code. You may continue entering Relay A codes

until you finish (Press #), or the memory becomes full. You will automatically be exited from the program mode if the

memory reaches capacity. When memory is full you will not be able to enter this Sub-Mode and will receive an ERROR

if entry is attempted.

♦

♦♦

♦

Sub-Mode 2 (Delete Codes)

To delete codes enter the following;

(MASTER CODE) + 2 + (CODE TO BE DELETED)

Should you make an entry error, simply press the * key and enter the correct code. You may delete any access or

function code that you wish with the exception of the MASTER CODE. If the code you wish to delete is not found in

memory, the unit will respond with an ERROR and wait for another code to be entered. A GOOD BEEP will be sounded

once the code has been found and deleted. You may continue deleting codes until you finish (Press #).

♦

♦♦

♦

Sub-Mode 3 (Change Master Code)

To change your master code enter the following;

(present MASTER CODE) + 3 + (new MASTER CODE)

Should you make a code entry error, simply press the * key and enter the correct code. You may select any 4 digit master

code you wish. If you receive an ERROR, you must select another code as it is already in use. The unit will respond

with a GOOD BEEP with the acceptance of the new Master Code and you will be exited from the program mode.

MAKE SURE TO WRITE THE NEW MASTER CODE DOWN.

Page 8 Page 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commenti su questo manuale

Nessun commento

American access system ADV-1000 Manuale delle Istruzioni Pagina 9

Commenti su questo manuale

Prodotti e manuali riguardandi Tastierini numerici American access system ADV-1000