American access system ADV-1000 Istruzioni per gli Interventi Scaricare il pdf (Pagina 13)

Page 13 © American Access Systems

Program Relay “A” Access Codes - Sub-Mode 1

To program Relay “A” access codes, use the following steps:

- Enter 1 2 5 1 (or, if the factory MASTER CODE has been changed, enter the programmed

MASTER CODE)

- Unit will sound a GOOD TONE

- Enter the numeral 1

- Unit will sound a GOOD TONE

- Enter a four-digit code combination other than the MASTER CODE (for example enter 4 3 2 1)

- If you receive an ERROR TONE after an entry it means that particular code is already assigned

and you must select another code

- If you make a mistake during entry, press the star (Å) key, then re-enter the code.

- When a new code is accepted the unit will sound a GOOD TONE

- Continue to enter codes until you are finished

- When you are done, press the pound (#) key to exit the programming mode

NOTES: You will automatically be exited from the programming mode IF:

 The memory reaches capacity

 The memory is full, you will not be able to enter Sub-Mode 1 and you will receive an ERROR TONE if

you try to enter this Sub-Mode.

 To enter new codes if the memory is full, you must first delete codes some of the codes already in

memory.

 Contact AAS if there seems to be a problem programming additional codes.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Nessun commento

American access system ADV-1000 Istruzioni per gli Interventi Pagina 13