American access system ADV-1000 Istruzioni per gli Interventi Scaricare il pdf (Pagina 15)

Page 15 © American Access Systems

NOTES:

- Be sure to make a note of the new Master Code. It is the password to system operation.

- If the Master Code has been forgotten or lost, and you cannot enter Sub-Mode 3, you must

perform a Master Reset which will reset the Master Code to 1 2 5 1. You can then use Sub-

Mode 3 to change the Master Code.

Set Sleep Code -- Sub-Mode 4

DETAILS: The Sleep Code is used to disable all Relay A and Function Codes from the keypad. This feature is

most commonly used in applications where no entry is desired after hours. Relay B codes will continue to

be valid from the keypad. By connecting both relays in parallel, managers may be assigned Relay B

codes and still gain access. While in the SLEEP MODE, the yellow and red LED's will flash every 3 seconds.

To initialize the system back to normal, simply re-enter the Sleep Code. Should you lose or forget the Sleep

Code and the unit is in the sleep mode you must complete a Master Reset. See the instructions on pages

20 and 21.

To program or change the Sleep Code:

- Enter the current Master Code

- Press the numeral 4

- Unit will sound a GOOD TONE

- Enter a new Sleep Code (If you hear an ERROR TONE, select another code that is not already in

use)

- Unit will sound a GOOD TONE

- If you make an entry error, simply press the star (Å) key and enter the number you wish

- When the new Sleep Code is accepted you will hear a GOOD TONE

- Press the pound

(#) key to exit the programming mode

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Nessun commento

American access system ADV-1000 Istruzioni per gli Interventi Pagina 15