American access system ADV-1000 Istruzioni per gli Interventi Scaricare il pdf (Pagina 23)

Page 23 © American Access Systems

Troubleshooting

Problem Solution

When I enter 1 2 5 1 on the keypad the

gate will not open.

1 2 5 1 is the Master Code or programming access code. It will

not open the gate unless the unit is in sleep mode.

Program a gate access code into the unit using Sub-Mode

1(listed in the programming instructions).

No response from keypad. Verify power input across the two white wires on the main

harness. Check blue night light LED’s to see if they are on.

Check for burn marks on the circuit board from a lighting

surge. Contact American Access Systems, Inc.

After I enter the latch code to hold the

gate open it closes or cycles open and

shut.

An open override circuit must be enabled in the gate

operator to prevent the timer circuit from overriding the

keypad when it is in a latch mode. Contact Gate Operator

manufacturer.

When I enter a valid Access Code the

gate does not open.

Locate the two wires attached to the Brown and Orange wires

on the main wire harness, then, touch them together. If the

gate does not open, check wiring or the connection terminals

on gate operator. If the gate opens, contact American

Access Systems.

I connected the two white power wires

together to one power source wire and

the other power source wire to the

green wire but the keypad doesn’t

work.

The green wire is for EARTH GROUND only. Connect one white

wire to one power source wire and the other white wire to the

second power source wire.

When I press 1 2 5 1 on the keypad

nothing happens and I hear an endless

set of error tones.

Contact American Access Systems Inc.

I want to reset my keypad but when I

push the reset button nothing happens.

Consult instructions regarding MASTER and UNIT reset for

proper reset sequence.

1 2 ... 18 19 20 21 22 23 24

Nessun commento

American access system ADV-1000 Istruzioni per gli Interventi Pagina 23